this is my ski. im doing some mods this winter just needs a tune its got factory b pipe Riva girdled head with 35cc domes Riva F/A MSD enhancer solas impeller Riva Tri-loader intake grate cyclone foot holds hydroturf diamond moulded aftermarket handle bars
dunno what its like it hasn't been on that water since April when i installed the foot holds and i just finished putting in the Riva Kit yea its a wet pipe. kit was about 3400 all up with custom and freight charges it would of been cheaper direct from Riva but they said any order coming to NZ would have to go through watercraft world ive been trying to get out but the weather been real crappy lately
no i haven't had it out yet gonna try get it out this weekend if i finish putting in my new bit and the weather holds up just an update i got my parts from Blowsion today bilge fitting handle bar bilge switch primer kit bow eye long john silver mikuni adjust screws odi lock on grips
I just ordered some parts from riva and they said nothing about having to go through watercraft world. Thank god for that. I hate that place.
the switch was 75us and i still had to add some heat shrink to it it didn't look that waterproof. but hey i got it on the handlebar it mount under the stop start switch
Hate to be a kill joy but Iv had a bad run with those switches. I had two of them on my last super jet and they both stuffed out real quick. I was a tad annoyed cos they are high dollar switches! I found the old sealed toggle switch to be the most reliable. Hopefully the extra heatshrink makes a difference. Be keen to hear about how it last for ya!
i found out that would most likely be the case after i got it. but ill see goes i don't ride much in the surf
bildge switch hey Vman those bilge switches work grate but you have to spin the start/stop switch forward from the standard position to get the bildge switch in a better position. I will post a photo of mine
i finally got my ski out Saturday it a lot more responsive now it jumps out of flat water with little effort just got a few problems to sort out now. the chamber on the pipe rubs on the hull and there this fine black dust where its been rubbing and my bilge pump came loose ill have to glue it back down
just an update with a list of all the bits i put on Factory b pipe mod chamber Riva girdled head with 35cc domes Riva F/A Riva reed stuffers MSD enhancer Solas impeller Riva Tri-loader intake grate R&D extended ride plate Cyclone foot holds Hydroturf diamond molded After market handle bars ODI lock on grips Primer Bilge pump with bar mounted switch Rejetted carbs 135main 75 pilot stock needle and spring may need some more tuning after i installed the stuffers last night. now its time to get some riding done