Pump Alignment

Discussion in 'Tech Discussion' started by korned, September 28, 2009.

  1. korned

    korned Member

    So just rebuilt my pump and went to bolt back onto ski, how do I ensure the pump is aligned correctly?

    I have shims but stupidly did not take a pic or note down exactly what mount they came from...... FAIL...
    korned, September 28, 2009
    #1
  2. jeton

    jeton Member

    pump

    if you put the first bolts on were jet comes threw from motor do them up thgen shim front ones
    jeton, September 28, 2009
    #2
  3. Aquanob

    Aquanob Active Member

    move the motor foward and remove the bulk head shaft, then bolt the pump in with no shims and look into the engine bay and make sure the pump shaft is in the middle of the hole, if not then shim it till it is.
    Aquanob, September 28, 2009
    #3
  4. wingie

    wingie Member

    whats this shimming the pump thing , never had to do that on any off mine , hell done even have to shim the engine , hang on you ride one off those silly poper jets that explains it all :lol: :twisted:
    wingie, September 29, 2009
    #4