Can someone tell me if they have installed a blowsion lowered pole bracket and how they done it? The instructions say to take off half an inch from the spring but it seems it needs more taken off, and its a real struggle to line up? Any help would be good Cheers. Sickboi will have a good laugh at this.
Yup im laughing and ive done it.......I left my blowsion pole spring the stock length,but i had to guess bend the fuck out of it in the work shop bench vice to get it through that bracket spring retaining hole also i used my mexican mill drill press to axe cut that hole for the spring in the hull too, (fuel tank should be out to avoid adding more breathers), now my RRP pole is a medieval catapulte! hopefully scotty you have a friend or caring mrs because you will need a hand gettin the pole bolt through the spring without damaging the thread, also i found swearing helps lube it in.....i put my pole, bracket and spring together in the vice.....make sure you have cut hull holes first....when i did it i had 2 unfriendly breather tubes to manipulate count your self lucky with jus one!
Ha after about two hours we finally got it in. cut a lil bit more off and also added some bends. I am also now the owner of a very erect pole, no need for the standard clip to hold it up anymore haha. cheers
