Separate names with a comma.
Make sure the out side seal has the 4 little tabs on it. If it has the 4 tab seal on the inside it will push the seals out
Yeah I should be but I took my little boy out in the 4wd instead
Yeah they don't turn as sharp as a superjet. But I love them in the surf.
Cool ski. I reckon they are they are the best aftermarket hull out there.
You can use the 760 front cover and it will allow you to run digital ignition charging on your superjet. The downside is the flywheel weight. I took...
Yes Jeff I know there have been some bad ignitions over the years I sold some as well that gave issues. factory pipe did some called the factory...
Do your research before buying an epic ignition if you still want one after that then go for it. Ajsp has about 5 in stock that have been back to get...
This is not going to end well. just walk away from it, these things are a piece of crap.
They were common accepted as not making much difference at all. there may be better places to spend your money
Cool looking ski
Looks good. I reckon that 1100 will empty the fx1 tank in a hurry. I always weld intake grate and ride plate together to stop the load on the pump...
Did you glass in new front mounts or make a bracket to use the orginal
Looks awesome, have you ridden it yet
The r&d ones use studs and they are on an angle but not to much that the studs will not go through.
exhaust and intake
I use oem on the base gasket as well.
If you have a broken reed valve it doesn't show up in a compression test If oil brings it up then its because it is sealing something up. Normally...
Damn it. I miss riding there
commonly known as the yamaha giraffe ffs dont wave jump it you will pull the steering out of the top deck
Thats good advice for sure. I have had the same issue myself with rad wheels. I have found by using grinding paste and loctite I was sucessful in...